Do many people have such troubles? Some people buy large machinery that needs to be replaced within a few years of use, while others use large machinery that has been in use for several years but is still very durable, even like newly purchased ones. What is the situation?
Actually, everything has a lifespan, and the same goes for large machinery. So we need to be careful in our daily operations, as improper operation can directly affect the service life of the machine!
Today we will talk about how to operate the excavator's diamond arm to extend its service life!
Excavator diamond arm is a device currently used by many people, mostly for breaking stones, so the power is very high and the pressure of the oil cylinder is also very strong. Only in this way can the machine have enough power to work.
Because excavators have pipelines, including hydraulic oil pipes, diesel oil pipes, engine oil pipes, grease pipes, etc. So we must preheat for a few minutes before starting work, so that the pipeline can run smoothly and the machine can run smoothly!
The noise of a cold start is usually loud, let alone letting the machine work directly. If the oil circuit has not reached a certain temperature, the working device will be powerless, and the pressure inside the oil circuit is very high. If you directly go to break stones, the pipeline will bear a lot of pressure, and the internal components of the excavator's diamond arm will also bear a lot of pressure. Therefore, do not do such operations.
We can gradually stabilize the oil temperature through preheating, and the engine will also start to stabilize gradually. This fully demonstrates that preheating is effective. At this time, we can start working, which can not only protect the excavator arm well, but also ensure the quality of work.
Most of the time, the excavator arm is used for crushing or digging stones. How should we operate it when facing such working conditions?
It is precisely because we have been dealing with stones for a long time that we all understand the physics of friction and heat generation. Therefore, we need to take a break after working for a period of time. Don't skip a break just to work in a hurry! Because when the temperature reaches a certain level, the hardness of steel will decrease!
If you continue working, the front device may bend! Do not use cold water to irrigate in order to continue working, as this is a very harmful practice to the machine!
Be sure to wait for the front device to cool naturally, so as not to harm the machine!
Post time: Sep-20-2024